Nuvo Lighting Laguna Collection

The standard base for Nuvo’s Laguna Collection Hanging Chandelier is an E26 lamp base. This lamp base is included with the fixture. If you’re looking for a replacement base, find an E26 base adapter today at HomElectrical!

Before fitting Nuvo’s Laguna Collection Pendant light, please consult with a licensed electrician. To fit the pendant light, the electrician will follow the rules from Nuvo’s Installation guide.

Below are some of the steps to fit the pendant.

• Step 1: The electrician will turn off the power and check to see if all the pieces are included. Then they will assemble the fixture by threading the tube to the desired hanging height. Once they finish threading the tube, they will thread the tube into the canopy and the body.
• Step 2: Once the electrician is finished assembling the fixture, they will begin the installation. To start they will measure the fixture and then use that measurement to cut a hole in the wall. Then they will thread the mounting screw into the match hole of the cross bar. The electrician will also secure the cross bar to the outlet box with screws.
• Step 3: Then the electrician will connect wires from the fixture to the corresponding wires in the wall. The electrician will need to pay close attention to each wire so that the light will work when the power is turned back on.
• Step 4: After the wires are connected, the electrician will tuck them inside the outlet box and raise the canopy. Then they will place the tuber over the sockets and install bulbs.
• Step 5: After installing the bulbs, the electrician will turn the power back on and ensure the light fixture works.

To replace a Nuvo Laguna Collection vanity, an electrician will follow the below steps:

• Step 1: The electrician will need to turn off the power. This can be done by turning the circuit breaker off.
• Step 2: Once the power is turned off, the electrician will remove the bulbs from the fixture.
• Step 3: Then they will unscrew the fixture and separate it from the wall.
• Step 4: The electrician will then disconnect the wires connecting the vanity to the wall wires.
• Step 5: Once the wires are removed, the electrician will get the new vanity fixture.
• Step 6: Then the electrician will install the new vanity by connecting the wires to the corresponding places in the wall and mounting the fixture.
• Step 7: Once the fixture is on the wall, the electrician will turn the power back on and see if the fixture works.