Nuvo Lighting Lansing Collection

• To install Nuvo’s Lansing Collection flush mount, first remove the contents from the box.
• Then make sure to turn the power off to prevent serious injury from happening. Once the power is off, thread the mounting screws into the mounting bracket.
• Then secure the mounting bracket to the outlet box with the outlet box screws. After that, fix the wiring from the light fixture to the corresponding wires in the wall.
• Once all the wiring is completed, place the wires inside the outlet box and raise the canopy so the mounting screws can be fastened.
• Finally, install the bulbs and place the glass over the bulb to complete the installation. Turn the power back on to check to if the light works after.
• Disclaimer: If you are not a licensed professional in electrical wiring. HomElectrical does not recommend DIY installation. Always hire an electrician for any, and all, electrical needs.

Yes, you can convert a recessed light to pendant lighting. To convert the can light, you need a recessed lighting pendant converter kit.

1. To start the conversion, remove the light bulb from the recessed light fixture.
2. Then measure the height that you want the pendant to hang. Loosen the compression nut from the canopy on the light kit.
3. Next, pull the cord through the canopy until it is the desired height. Screw the kit into the light bulb socket like you are screwing in a light bulb.
4. Raise the canopy until it is flush with the ceiling. After this, you can add your light bulb and the conversion is complete.

Before mounting Nuvo’s Lansing Collection 2-Light Wall Sconce, follow the included installation instructions. The step-by-step instructions are included below:

1. Carefully unpack the fixture
2. Unpack the fixture and lay out all parts or accessories on a flat surface
3. Using the 2 outlet box screws, fasten the cross bar to the outlet box
4. From the outlet box, tie the ground wire from the fixture and the outlet box to the cross-bar ground screw.
5. Connect the white fixture wire to the neutral white wire from the supply circuit.
6. Next, connect the black fixture wire to the live black wire from the supply circuit.
7. Cover the connections with the provided wire connectors.
8. Place the fixture on the wall, making sure to align the mounting screws through the wall plate and tighten the screws until the light fixture is firmly secured.
9. Install an LED bulb (not included in purchase)
10. Turn on power to the fixture for use

Disclaimer: If you are not a licensed electrician, we do not recommend DIY installation. For any, and all, electrical wiring needs contact a licensed electrician for assistance.