Nuvo Lighting Spyglass Collection

To install Nuvo’s 60W Spyglass Series Wall Sconce follow Nuvo's Installation guide. Below are the steps you can follow to install the wall sconce.

1. Turn off the power to the circuit breaker and remove the contents of the fixture on a clean surface.
2. Then thread the mounting screw to the matching hole of the mounting bar.
3. Once you match the mounting screw, secure the mounting bar to the outlet box with outlet box screws.
4. Insert the grounding screw into the hole on the mounting bar. Then wrap the ground wire from the fixture around the grounding screw and connect it to the ground wire from the outlet box using a wire connector.
5. After connecting the grounding screw to the mounting bar, connect the wires from the fixture to the corresponding wires in the wall. Make sure to cover the wires with wire connectors.
6. Once the wires are connected, put them in the outlet box. Then raise the canopy so the mounting bar goes through the canopy and secure it with finials.
7. Install the light bulb and raise the glass shade to the glass holder and put it in place with screws.

This completes the installation!

Disclaimer: If you are not a licensed professional in electrical wiring, HomElectrical does not recommend DIY installation. Always hire an electrician for any, and all, electrical needs.

To install Nuvo’s 60W Spyglass Series Mini Pendant Light, hire a licensed electrician. This will prevent you from serious injury. Below are the steps they will follow to complete the installation.

• Step 1: Turn off the power to the circuit breaker. Once the power is off, take out the contents of the fixture and place them on a safe surface.
• Step 2: Thread the mounting screw into the mounting bar.
• Step 3: Secure the mounting bar to the outlet box with the outlet box screws.
• Step 4: Put the grounding screw into the mounting bar. Wrap the ground wire from the fixture around the grounding screw and connect it to the ground wire from the outlet box. Use a wire connector if not supplied.
• Step 5: Connect the black wires from the fixture to the black wires in the outlet box. Then repeat this by connecting the white wires to the white wires from the outlet box.
• Step 6: Once the wires are connected, put them in the outlet box. Place the canopy over the mounting bar and secure the mounting bar with finials.
• Step 7: Once the canopy is on, add light bulbs to the fixture and raise the glass shade to the glass holder and put it in place.
• Step 8: Turn the power back on and test to see if the light works.