Qmark Specialty Unit Heater

Commonly referred to as plenum-rated, zero clearance compact unit heaters from QMark are great options for spot heating. They are commonly installed in:

• factory assembly lines
• outdoor concession stands
• basements/attics
• areas between a structural ceiling and a drop-down ceiling
• any area that receives less sunlight

These plenum heaters can be installed in the following ways:

1. Mounted in the horizontal-right installation position
2. The unit can be rotated on its axis in any position needed (can not be mounted vertically).
3. Units can be independently suspended with support channels or straps (be careful not to obstruct access to control panel with support channels or straps.

All maintenance and repair should be performed by qualified personnel only.

1. Make sure to inspect all electrical connections and terminals periodically.
2. To avoid electrical wiring difficulties, inspect all wiring for frayed or worn insulation.
3. Keep the exterior surfaces clean of dirt and dust with compressed air, a vacuum, or dust brush.
4. If the fan or motor ever needs to be replaced, make sure it is an identical factory supplied motor or blower